From case-specific to general tuning: A structured, system-level framework for scalable RCCI simulation
Lopullinen julkaistu versio - 8.79 MB
Golbaghi, K., Maleki Almani, H., Kakoee, A., Smulter, B., Hyvönen, J., Andwari, A., & Mikulski, M. (2026). From case-specific to general tuning: A structured, system-level framework for scalable RCCI simulation. Energy conversion and management, 361.
https://doi.org/10.1016/j.enconman.2026.121622
© 2026 The Author(s). Published by Elsevier Ltd. This is an open access article under the CC BY license (http://creativecommons.org/licenses/by/4.0/).
Lataukset32
Pysyvä osoite
Kuvaus
Multi-zone models (MZMs) are widely used for system-level simulation of reactivity-controlled compression ignition (RCCI) engines. However, their predictive robustness remains strongly dependent on CFD-informed fuel stratification inputs, case-specific calibration and fuel-dependent chemical kinetic mechanisms. This limits their transferability across engine platforms and operating conditions. This study addresses these limitations by developing a structured, CFD-independent reduced-order predictive framework for scalable engine-level RCCI simulation. Implemented within the University of Vaasa’s advanced thermo-kinetic multi-zone model (UVATZ), the methodology integrates (i) systematic reactivity scaling to compensate for chemical kinetic deficiencies without disturbing thermodynamic boundary conditions, and (ii) a generalised beta-distribution-based highreactivity fuel stratification model which eliminates reliance on CFD-derived mixture profiles. The framework is encapsulated in a modular solver architecture and uses a structured calibration procedure requiring only limited test-bench data to achieve predictive capability. The new submodels were assessed for scalability across different chemical kinetic mechanisms, and their physical consistency was verified against CFD spray simulations. The complete framework was experimentally validated using 40 operating points from a prototype Wärtsilä W31 medium-speed dual-fuel engine operating in RCCI mode. Key performance metrics (maximum pressure and indicated mean effective pressure) were predicted within ± 6%, without case-specific tuning. CA50 errors were below 5 CAD (±1 CAD standard deviation). Model deviations remained within measured cycle-to-cycle variability, and simulation time did not exceed three minutes per cycle, comparing favourably against best-in-class multi-zone models which rely on calibration to a specific operating point.
Emojulkaisu
ISBN
ISSN
1879-2227
0196-8904
0196-8904
Aihealue
Kausijulkaisu
Energy conversion and management|361
OKM-julkaisutyyppi
A1 Alkuperäisartikkeli tieteellisessä aikakauslehdessä (vertaisarvioitu)